![]() ![]() Press the power switch to turn on the transmitter.Press the power switch to turn on the quad-copter.When the quad-copter indicator flashes slowly, push the throttle lever to the highest position, and then pull it back to the lowest position.When all else fails, restore factory default settings by the following methods: I have done everything else, and am still experiencing issues. Check monthly and recharge as needed.When charging, place product on a dry, well-ventilated surface and keep away from heat sources.Ĭlick here to see our battery replacement guide If battery sees no use for extended periods of time, it is recommended that battery voltage is kept above 3V. Do not use or leave battery near a heat source such as fire or space heater exposure to heat may result in reduced performance or in some cases dangerous conditions.Charge battery to approximately 55% capacity prior to long-term storage.If battery is left in charging state for an extended period of time after being fully charged, the battery may automatically discharge.Īs battery temperature is high immediately after flight, charge it after it cools down for Insert Four (4) x ‘AA’ batteries according to indicated polarities. Unscrew and remove battery cover from controller, using the included screwdriver.How to replace batteries in remote control. Reset the trim buttons on the controller and re-trim flight controls.Ĭlick here to see our blade guard replacement guideĬlick here to see our rotor replacement guide ![]() Ensure that the Dronium Two is on a flat and level surface prior to beginning pre-flight procedure. If the Dronium Two is unsteady in flight, it may not have been able to calibrate horizontally Power down both vehicle and remote control, and then restart pre-flight procedure. Your Dronium Two is experiencing unsteady flight. Then, turn on the remote first and then plug the cable back into the Dronium Two to turn it on. Turn the remote off and unplug the cable from the Dronium Two.If the Dronium Two and the remote do not sync after following the pre-flight checklist, reverse the first two steps of the process as follows: If the quad-copter’s LED blinks slowly, it means it has not recognized the controller please restart pre-flight procedure. Turn on the controller if, after 30 seconds, it has not recognized the helicopter, turn off controller to retry synchronization. This shows that the quad-copter has synced with the remote. There will be one beep from the transmitter. Push the ON/OFF power switch toward ON.Open the battery cover on the Dronium Two and insert the battery into the power port.Close the battery cover and turn on the quad-copter.Push the throttle lever to the highest position, and then pull it back to the lowest position.The drone will not respond to commands from the remote control. Student-Contributed Wiki #Īn awesome team of students from our education program made this wiki. The Protocol Dronium Two is a remote controlled quad-copter with a high definition camera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |